T.M.
Facetron - Jarvi Tool Company - Anaheim, CA USA
T.M.
Facetron - Jarvi Tool Company - Anaheim, CA USA
    |
|
|
 After
you dial in the desired angle on the digital protractor of the Facetron,
the dial
indicator stop system shows you
the exact stopping point. The dial indicator stop system consists of a
new hard stop and dial indicator for dependable and accurate depth of cuts.
You have three options. you can use dial indicator as dial stop only, hard
stop only or both.
The dial indicator resolution is .0005 of inch increments. More information |
 Micro-height
Adjustment makes it easy to
go back to any facet after the dop has been removed from the dop chuck.
No
numbers to write down. It's quick and simple. This feature is particularly
helpful in production faceting or when sharing your machine. The Facetron
can roll back to any facet by setting the angle the stone was cut at on
the digital protractor and reading the dial indicator. |
 Two
Quart Water Coolant System keeps your lap clear and stone cool so
as not to damage either. It's easy to refill, and is fully positionable
on the lap. The control valve is conveniently located away from the spout. |
Powerful Permanent Magnet Motor custom made for Facetron, supplies variable speeds through a direct line V-belt drive with plenty of torque over the full range of RPM's. Sealed bearings provide maximum life and dependability to the platen. The motor mount swivels to accommodate belt tension adjustments. |
| Urethane Splash Bowl with Padded Lap Nut prevents accidental damage of precious stones. The spent cooling water conveniently drains through the bottom of the base. | The Base is 12" x 18" x half inch cast aluminum, Blanchard ground to be absolutely flat. This provides you with the confidence that your machine is mounted on a steady base. Also included is a genuine oak veneer base to highlight this fine precision instrument. |
 Dop
Chuck with exclusive Cam Lock System (not
a jam-nut-collet or set screw) provides positive lock system on keyed
dops that makes it easy to remove & replace your stones in the chuck
with perfect orientation. This feature is invaluable for multiple
unit production cutting. The entire system is assembled with precision-sealed
ball bearings to guarantee long-life and perfect repeatability. |
 The
Index Wheel is
by far the most important component of any faceting machine. Facetron's
advanced design is machined without compromise for precise meets of the
facets on your valuable stones. Index Wheels are machine engraved for easy
viewing. |
 The
Digital Protractor provides
you with 1/10 of a degree angle settings (equivalent to a four foot protractor!).
It also allows you to repeat any desired angle quickly and precisely. This
makes other machines things of the past. |
Mast Head Adjustment Lever makes moving the head height quick and easy. Eliminates the cranking that many other machines require when lifting the head over long distances. There's no need to write down numbers either. |
| Mast Anchor Lever locks with a feather touch and a hard anodized base permits a smooth movement with minimum wear. Maximum flexibility to work on stones of all sizes and shapes. |  The
Electronic Speed Control puts you in control of your lap speed and
incorporates an on-off switch. You decide on speeds from as low as one
rotation-per-second up to 1600 rotations-per-minute with continuous high
torque. |
Complete Facetron Kit includes all you need to begin making fine gemstones except laps.
780 East Debra Lane - Anaheim, California 92805
Phone: 714-774-9104 - fax 714-774-9105 - email jtfacetron@earthlink.net
Copyright © 1998 - 2008, Jarvi Tool Company, All rights reserved
